cmore
Newbie RV’er
Posts: 34
|
Post by cmore on Aug 19, 2014 10:51:12 GMT -5
I recently purchased a 2011 14fkth. Have not been able to get much documentation on the RV. This is my first RV and have been able to find out quite a bit but still am needing more. KZ has not responded to any of my requests. Please point me in a good direction to find out more. One is the power panel has a 15amp fuse that was blown and blows every time I put in a fuse. DC outputs 4-6 and marked but 1 and 2 aren't. #1 is the location were the fuse blows. Does any one know what circuit it protects?
Thanks
|
|
|
Post by indyhntr on Aug 21, 2014 4:59:05 GMT -5
I would suggest that you turn EVERYTHING in the trailer that is 12volt on and see what doesn't work. Don't forget the radio, furnace, monitor panel, etc. Kind of a crude way of going about it but at least you'll know.
|
|
|
Post by skootz on Aug 23, 2014 7:33:49 GMT -5
Any luck finding info yet? We have a 2013 16fkth but I don't know if they have the same power panel. I can post a photo later so you can see it.
|
|
cmore
Newbie RV’er
Posts: 34
|
Post by cmore on Sept 10, 2014 21:14:19 GMT -5
Was unable to get any support from the manufacture or original selling dealer. Decided that I was going to mess something up or fix it. Luckily I've fixed it. The power panel has 6 DC,fused circuits. 1 and 2 were not labeled. 3-6 were. #1 would blow a fuse as soon as it was installed. Tried to get help from the original dealer and manufacturing company. Decided today I was going to get to the bottom of the issue or mess something up. Finally decided I had to un-attach the power/fuse box panel and slide it out to see what I could see. Found that 2 wires were not attached to anything. That would lead u to believe they were the 2 un-identified circuits ,1 and 2 would be unattached/unused. After loosening the circuit board to see which color of wire were attached to what circuit #. Found that the #1 wire laying close to the ground block and must have been touching it as they did not insulate either of the 2 end of wires for the un-used power taps. The one to circuit 3 was un-attached but circuit 2 was being used. So at the factory they hooked up the wrong wire and or miss labeled the circuit legend. So now have circuit 3 open and hooked circuit #1 to a 12v DC power source. Read more: kzfamilyforum.com/thread/600/kz-14fkth-dc-circuits-std#ixzz3Cy7hkKETskootz, All is good now My power panel is a WF-8735p WFCO (a 35 amp panel), which should be the same or similar.
|
|
cmore
Newbie RV’er
Posts: 34
|
Post by cmore on Nov 14, 2014 21:18:52 GMT -5
Got some of the documentation for the 14f today. Evidently the first manuals got lost int the mail. Did not get the documentation for the installed appliances but just general RV info tho.
Not as big of a issue as have been able to track down the information on internet.
|
|