|
|
Post by chulavista on Jul 13, 2021 23:36:10 GMT -5
Hey gang! These questions are specifically for 382MBQ owners: first, does your unit have the 2" receiver hitch on the back? Second, do you have latches / locks for the legs for the awning that covers the back deck? If so, where are they mounted?
thanks gang!
Kathy & Lloyd
|
|
bobnmonica
Seasonal RV’er
2020 GMC Diesel Denali Dully, Durango Gold MBQ 382
Posts: 101
|
Post by bobnmonica on Jul 17, 2021 13:09:42 GMT -5
No, it does not have a hitch, studying mine, you could weld a cross member or 2 and install one but load rating would be very low and not certified. The legs are held up by pins with clips but for some of the sites we have been in they are not long enough. I do wish that the slid8 g doors opened up both sides to be able to put like E-Bikes inside or small electric carts (we have 2 carts in the storage area) we bought a 2021 model but it is really 2020 model our only issue with KZ, well it’s our second. The chucking was very noticeable (2020 GMC Dully B&W slider) and at a rally replaced the pin box with a Moride. When they removed the original one, 3 bolts were stripped out and possibly get ripped off. Emergency break would not have worked as it is attached to the box.
|
|
|
|
Post by Edd505 on Jul 17, 2021 23:07:44 GMT -5
Mine came with the Lippert Rota-Flex coupled with the B & W Companion it's the smoothest combination I have had,but I tow with a long bed F350. Is your hitch over the rear axle?
|
|
|
|
Post by Chuck on Jul 18, 2021 16:03:51 GMT -5
we replaced out Lippert Rota-Flex with a MorRyde 18K pinbox before we took the trailer off the lot, we also have a B & W hitch an have no chucking  Chuck |
|
|
|
Post by chulavista on Jul 19, 2021 9:58:36 GMT -5
The legs are held up by pins with clips but for some of the sites we have been in they are not long enough. The legs are held up by pins with clips, where are these pins and clips attached? Ours doesn't have them. |
|
bobnmonica
Seasonal RV’er
2020 GMC Diesel Denali Dully, Durango Gold MBQ 382
Posts: 101
|
Post by bobnmonica on Jul 28, 2021 18:59:37 GMT -5
The clips are attached to the pins, one just holds up the leg on to the mount and the other locks the leg extension in place. The trail air was the one that got replaced. The replacement did not help the chucking issue, just the stripped out bolts were the safety issue
|
|
|
|
Post by chulavista on Jul 28, 2021 19:14:02 GMT -5
The clips are attached to the pins, one just holds up the leg on to the mount and the other locks the leg extension in place. Is there a place to mount on the deck? I understand the clips on the legs, but they are useless unless they attach to something, I assume on the deck or the wall near the door. There is nothing on either location to attach the legs to on my trailer. |
|
