quark
Newbie RV’er
Posts: 9
|
Post by quark on Jun 1, 2013 11:10:41 GMT -5
I have a fairly new Durango 2500. A problem has developed where the gray water tank level alert is always showing full. I can empty it, and it correctly shows empty on the panel. But as soon as any waste water goes into the tank, the beeping starts, and the panel shows 2/3 full.
The trailer is stationary and level.
Has anybody encountered this problem? Got a solution?
Thanks.
Roger
|
|
|
|
Post by joecamper on Jun 1, 2013 21:13:35 GMT -5
My Durango does that also. My fresh tank pretty much does the same thing. I've read of ways to "clean" the sensors, but none of those would work for a fresh tank. I'll keep a watch on your post to see if someone has a "magic" cure.
|
|
quark
Newbie RV’er
Posts: 9
|
Post by quark on Jun 17, 2013 22:59:47 GMT -5
This is an update to my original post regarding the level sensors in my Durango 2500. After reading some online blogs, I decided to add some laundry detergent in the grey water tank, and let it slosh around around on my next drive. It worked like a charm. I dumped the tank, added some fresh water back in, added enough detergent for a single washer load, and then drove to my next location. Problem solved.
It's important to use laundry detergent. Most other soaps will foam too much. That would NOT be good.
Roger
|
|
