73jer
Newbie RV’er
Posts: 17 
|
Post by 73jer on May 27, 2017 22:51:00 GMT -5
Well, my new 366FBT has a bit of a problem with the main slide awning LED light strip. Has been working fine. I guess I've used it 3 or 4 times now. Just noticed it wasn't working so I got to looking for a blown fuse. Look where I found it. IN THE DADGUM WALL! Unless you really dig for the wires and pull them out you will never find it. What were they thinking? Unfortunately, even though I found the fuse, and it was blown, when I replace it it immediately pop the new one. I think I have a short in the line. I'll have to trace it out when I get home. Not going to work on my vacation. Leaving the fuse out and back to the campfire.  - John |
|
|
|
Post by Chuck on May 28, 2017 10:56:54 GMT -5
73jer Yesterday I was looking at my awning on the main slide, I noticed a thin wire coming from the trailer side into the very edge of the awning. It looked like it was sewn into the edge of the awning and came out at the LED light strip in the roller. So what my take on it is that every time you roll or unroll your awning you are rolling and unrolling that thin wire sewn into your awning ... Like someone said in another post, I think it would have been better to put the LED light under the awning on the trailer. Another question for the people at Kz at the Rally, my list is getting pretty long now LOL Safe Travels & Don't forget about the Kz Rally this Summer  Chuck |
|
|
|
Post by johnr on May 30, 2017 6:50:02 GMT -5
I'd start my checks outside the unit, where the power line leaves the wall. Maybe something got wet or some bare wires moved so they were touching?
|
|
