|
|
Post by fpopjfj on Jul 8, 2016 12:55:06 GMT -5
Well, took my new 2016 Spree Escape Toyhauler on its maiden voyage to a local State Park. All went good except when I went to hook up my portable satellite dish. There was not any connection from the outside satellite/cable connection to the inside connection. I took the chance of pulling the interior connection down from the ceiling, and wala nothing hooked to the satellite/cable connection. Luckily, the cable had been made to the wrong connection, so all I had to do was move the cable. All good after that, and I am very pleased with the new RV.
|
|
|
|
Post by poppachris on Jul 27, 2016 21:41:21 GMT -5
Interesting... Would it be possible for you to post a photo of your now correct connection? Might be helpful for some to compare.
|
|
|
|
Post by fpopjfj on Jul 28, 2016 9:02:40 GMT -5
The unit is in storage right now, so I cannot get a picture. But if you pull the 2 connection plate off the ceiling, you will see 1 connection goes to a little circuit board (amplified antenna connection) and the other connection should just have a cable from the outside cable connection. Mine had both cables going to the amplifier board and nothing going to the cable connector. Hope this helps.  |
|
|
|
Post by paroadking1 on Jul 28, 2016 14:47:38 GMT -5
Similar problem on my 30TH. Cable and satellite were reversed. I just added new labels on the outside connections.
|
|
