|
Post by Bill Kitchen, Georgetown On.CA on May 16, 2013 0:14:58 GMT -5
I have just spend a rainy weekend camping and discovered four inches of water in the battery case. It appears on the Spree E18RBT the rain runs down the unopened front bed, off of the top of the stone guard on to the protective battery case cap. Since the cap has two vents in the top, the rain can flow in and there is no drain hole in the base of the case to stop the accumulation in the case. My concern is the possibility of the case filling up and shorting out the terminals and blowing up the battery next to the propane tank. 1) Can I drill holes in the bottom of the case for drainage? 2) Can I seal off the top two vents and rely on the air getting in under the cap?
What is the recommended fix here?
Bill
|
|
|
Post by lynnmor on May 16, 2013 2:49:10 GMT -5
You have it right. Drill at least 4 holes and keep them away from the frame parts below. There is plenty of ventilation under the cap on most boxes, so seal the vents.
|
|
|
Post by Bill Kitchen, Georgetown On.CA on May 16, 2013 23:42:45 GMT -5
Thanks for the confirmation here Lynnmor. I just don't know why the manufacturer would not have caught this by now and engineered it out.
Bill
|
|
|
Post by lynnmor on May 17, 2013 3:05:37 GMT -5
Thanks for the confirmation here Lynnmor. I just don't know why the manufacturer would not have caught this by now and engineered it out. Bill Years ago it was "engineered out." There were two kinds of battery cases made, one for marine use and one for RV type use. The cases made today are for use on boats. The dealers/manufacturers almost never used the correct one so it was discontinued.
|
|