|
|
Post by awdv6turbo on Jul 4, 2018 15:58:19 GMT -5
Ok so I have water coming in the window that pops out and is also under the air conditioner. When the AC is on water drips down the rear corner of the window inside the trailer. So I sprayed the seals and all with the clear flex seal stuff and covered the window with a trash bag. I duct taped it over the window under the air conditioner. Now I am still getting water running down that rear corner of the window. It's following a spot where 2 wall panels meet. I also have the trailer slightly tilted towards the ac side in hopes it would help but no. Any help would be greatly appreciated. I'm out with the tt as I type this and it's too hot a sticky to not use the ac.
|
|
|
|
Post by lynnmor on Jul 4, 2018 19:05:40 GMT -5
If this is a sidewall air conditioner, I know they had problems. You need to pull things apart and do it right, spraying stuff is not a repair. The trailer will be destroyed if water gets in the wall.
|
|
|
|
Post by grandpopsicle on Jul 30, 2018 7:34:23 GMT -5
Get a piece of u or j channel used for vinyl siding (very cheap) and cut a piece 2" longer than the acs width. Then carefully heat the last inch on each end enough so it softens and manipulate it so it points out and down...just a little. Doing this will allow the AC to drain away from the camper siding. Then use some dycor or simular to attach it under the ac. Practice the heating and bending part a couple of time before the finale piece. |
|
